• One-part, translucent, non-slumping RTV silicone adhesive
  • Based on a dimethyl silicone polymer
  • Non-corrosive cure
  • Shelf-life stability
  • Rapid curing
  • Excellent electrical insulation properties


  • As a sealing and caulking, adhesive or potting material for environmental protection of electronic assemblies and components where a non-corrosive cure is essential
  • As a coating for semi-conductors and integrated circuits
  • As an adhesive/sealant for electrical wires, terminals, mounting resistors and connectors
  • Ideal for overhead or side wall applications due to its non-slumping characteristics

Product Details

Property Average Result
Cure System Oxime
Extrusion Rate 70 g/minute
Lap Shear 485 psi (3.34 MPa)
Durometer 35 Type A
Appearance Translucent
Cure 7 days / RTV
Elongation 325 %
Flow Rate 0.5 in (12.7 mm)
Mix Ratio 1 PART
Non Volatile Content 100 %
Specific Gravity 1.1
Tack Free Time 25 minutes
Tear 40 ppi (7.05 kN/m)
Tensile 850 psi (5.86 MPa)
Comment Non-slump. Adhesive for a variety of substrates on or near electronic components. 485 psi (3.6 MPa), primed (SP-120) lap shear.


The diverse line of NuSil® adhesives specifically designed for electronic component assembly increases production throughput without sacrificing performance.

Read more

The test data shown for this material is the average value for typical properties. All of these properties may not be tested on a lot to lot basis and cannot be used to draft specifications. Please contact NuSil for assistance and recommendations in establishing limits for product specifications.