• 1:1 Mix ratio (Part A: Part B), Platinum addition cure
  • Controlled Aspect Ratio
  • Translucent
  • Cures at room temperature
  • Low Volatility
  • RoHS compliant


  • Applications that require non-slumping material
  • Cures quickly to form cure in place gasket in device
  • Can be easily removed after cure to reduce rework time
  • Leaves minimal to no residue once removed
  • Easily dispensed and consistent aspect ratio
  • Suitable for mix and meter equipment

Product Details

Property Average Result
Cure System Platinum
Extrusion Rate 0.08 g/minute
Durometer 30 Type A
Appearance Translucent
Cure 24 hours / RTV
Dielectric Strength 530 volts/mil (20.67 kV/mm)
Elongation 450 %
Tensile 850 psi (5.86 MPa)
Thermal Conductivity 0.18 W/(mK)
Volume Resistivity 100,000,000,000,000 ohmcm
Work Time 20 minutes
Comment Mobile Devices, Displace


The diverse line of NuSil® adhesives specifically designed for electronic component assembly increases production throughput without sacrificing performance.

Read more

The test data shown for this material is the average value for typical properties. All of these properties may not be tested on a lot to lot basis and cannot be used to draft specifications. Please contact NuSil for assistance and recommendations in establishing limits for product specifications.